SWD

From Proghq
Revision as of 16:34, 26 October 2021 by Mcmaster (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

STLinkV3

There's also voltage isolation accessory "B-STLINK-VOLT"

Connectors:

  • STDC14: 14 pin main connector. 7x2, 1.27 mm pitch
    • You can snap off the top and bottom pins to mechanically and electrically convert to MIPI10 if you really don't need the higher performance
  • MIPI10: STLinkV2 connector. 5x2, 1.27 mm pitch
  • MIPI20


Tag connect

https://www.tag-connect.com/debugger-cable-selection-installation-instructions/stlink-v3set

TLDR: I should have used TC2030-CTX-STDC14, but was sent TC2030-CTX. I can snap STLinkV3 pins to make them compatible if in a bind