SWD: Difference between revisions

Latest revision as of 16:34, 26 October 2021

There's also voltage isolation accessory "B-STLINK-VOLT"

Connectors:

STDC14: 14 pin main connector. 7x2, 1.27 mm pitch
- You can snap off the top and bottom pins to mechanically and electrically convert to MIPI10 if you really don't need the higher performance
MIPI10: STLinkV2 connector. 5x2, 1.27 mm pitch
MIPI20

Tag connect

TLDR: I should have used TC2030-CTX-STDC14, but was sent TC2030-CTX. I can snap STLinkV3 pins to make them compatible if in a bind

@@ Line 1: / Line 1: @@
-STLinkV3
+== STLinkV3 ==
+There's also voltage isolation accessory "B-STLINK-VOLT"
+Connectors:
+* STDC14: 14 pin main connector. 7x2, 1.27 mm pitch
+** You can snap off the top and bottom pins to mechanically and electrically convert to MIPI10 if you really don't need the higher performance
+* MIPI10: STLinkV2 connector. 5x2, 1.27 mm pitch
+* MIPI20
+Tag connect
+https://www.tag-connect.com/debugger-cable-selection-installation-instructions/stlink-v3set
+TLDR: I should have used TC2030-CTX-STDC14, but was sent TC2030-CTX. I can snap STLinkV3 pins to make them compatible if in a bind